Rules of Origin for welded angles, shapes and sections of steel — slotted angles — Dubai (UAE) to India
HS 73012010 · SHEET PILING OF IRON OR STEEL · Rules of Origin & preferential rate
Data last updated: · MFN duty & IGST verified against ICEGATE (Indian Customs EDI). Rules of Origin per CEPA Annex 3B. Verify your exact HS line before filing.
- CEPA eligible
- Yes
- Value addition (RVC)
- 40%
- Tariff-classification change
- CTSH Annex 3B rule set at chapter level — it covers the whole chapter, not this code alone
- MFN → CEPA basic duty
- 15% → 7.5%
Rule of Origin (CEPA Annex 3B, primary source): CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required).
Qualifying under the Rules of Origin
To claim the CEPA preference on welded angles, shapes and sections of steel — slotted angles (HS 73012010), the goods must qualify as UAE-originating. The Product-Specific Rule (Annex 3B) is "CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required)": the goods must undergo a change of tariff sub-heading (CTSH) AND add at least 40% regional value content — both conditions, not either/or. Read that rule for what it is: Annex 3B supplies it at chapter level, so it governs hundreds of eight-digit codes rather than this one. It is the correct rule to apply, and it is also the place to check for a more specific carve-out before committing to a claim. Steel slotted angles are the backbone of storage racking, shelving and light structures, a high-volume fabricated-steel import. The important detail on this line is that the concession is a Tariff Reduction over ten years and it does not reach zero — the schedule steps the rate down and stops at a floor, so this is a permanent partial preference rather than a path to duty-free. A supply contract priced on the assumption that the duty disappears is built on a misreading, and the rate also moves each year, so the current-year figure has to be checked rather than carried forward. The 40% value-content rule applies to the welded section, so origin depends on where the steel was rolled and fabricated. Steel trade remedies run in parallel, and the Steel Quality Control Orders require BIS certification of the producing mill. A valid Certificate of Origin filed through the eCoO 2.0 system must accompany the shipment; without it, customs charges the 15% MFN rate instead of the preference.
Check your own figures in the Rules of Origin (RVC) qualifier. Qualifying is only half of it — the preference is claimed with a Certificate of Origin, issued in the UAE before shipment or retrospectively within 12 months.
Frequently asked questions
- Does welded angles, shapes and sections of steel — slotted angles qualify for India–UAE CEPA?
- Yes, if it meets the Annex 3B Product-Specific Rule "CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required).": it must BOTH change tariff classification (CTSH) AND add at least 40% regional value content — both conditions are required, not either/or.
- What is the Rule of Origin for welded angles, shapes and sections of steel — slotted angles?
- Per CEPA Annex 3B: CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required).. RVC% = [(FOB − value of non-originating materials) / FOB] × 100 (FOB basis).
- What proof is needed at import?
- A preferential Certificate of Origin filed through eCoO 2.0, presented at customs before clearance. Without it, the 15% MFN duty applies.