Rules of Origin for welded angles, shapes and sections of steel — other — Dubai (UAE) to India
HS 73012090 · SHEET PILING OF IRON OR STEEL · Rules of Origin & preferential rate
Data last updated: · MFN duty & IGST verified against ICEGATE (Indian Customs EDI). Rules of Origin per CEPA Annex 3B. Verify your exact HS line before filing.
- CEPA eligible
- Yes
- Value addition (RVC)
- 40%
- Tariff-classification change
- CTSH Annex 3B rule set at chapter level — it covers the whole chapter, not this code alone
- MFN → CEPA basic duty
- 15% → 3.5%
Rule of Origin (CEPA Annex 3B, primary source): CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required).
Qualifying under the Rules of Origin
To claim the CEPA preference on welded angles, shapes and sections of steel — other (HS 73012090), the goods must qualify as UAE-originating. The Product-Specific Rule (Annex 3B) is "CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required)": the goods must undergo a change of tariff sub-heading (CTSH) AND add at least 40% regional value content — both conditions, not either/or. Read that rule for what it is: Annex 3B supplies it at chapter level, so it governs hundreds of eight-digit codes rather than this one. It is the correct rule to apply, and it is also the place to check for a more specific carve-out before committing to a claim. This residual line covers welded steel angles and sections beyond slotted angles, used across construction and fabrication. It sits mid-schedule, so the preferential rate is a reduction that steps down further each year — but unlike the slotted-angle line next to it, which stops at a floor, this one runs all the way to zero. That makes the classification between the two commercially significant rather than cosmetic, and the invoice description rarely settles it. Confirm the current-year rate on the schedule rather than carrying forward a figure quoted last season. Origin turns on the 40% value-content rule for the fabricated section, steel trade remedies may apply independently of CEPA, and the Steel Quality Control Orders require BIS certification of the producing mill before clearance. Settle all three with one enquiry to the mill. A valid Certificate of Origin filed through the eCoO 2.0 system must accompany the shipment; without it, customs charges the 15% MFN rate instead of the preference.
Check your own figures in the Rules of Origin (RVC) qualifier. Qualifying is only half of it — the preference is claimed with a Certificate of Origin, issued in the UAE before shipment or retrospectively within 12 months.
Frequently asked questions
- Does welded angles, shapes and sections of steel — other qualify for India–UAE CEPA?
- Yes, if it meets the Annex 3B Product-Specific Rule "CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required).": it must BOTH change tariff classification (CTSH) AND add at least 40% regional value content — both conditions are required, not either/or.
- What is the Rule of Origin for welded angles, shapes and sections of steel — other?
- Per CEPA Annex 3B: CTSH + VA 40% (CEPA Annex 3B Product-Specific Rule; tariff-shift AND value addition both required).. RVC% = [(FOB − value of non-originating materials) / FOB] × 100 (FOB basis).
- What proof is needed at import?
- A preferential Certificate of Origin filed through eCoO 2.0, presented at customs before clearance. Without it, the 15% MFN duty applies.